Using J18 TGT_BDM
Hi all,
we have a problem with the onboard OSBDM (JM60) on our TWR MCF52259 board. So we want to try for debugging and flashing the J18 connector with the P&E USB-ML-CF Multilink interface . Unfortunately there is nothing about using this 26 pin header in the documentation. I think the switching could be simply done by not using the OSBDM. So OUT_EN will not connect the signals to the MCU and we can use the external BDM (USB-ML-CF). Is this correct?
Walter
we have a problem with the onboard OSBDM (JM60) on our TWR MCF52259 board. So we want to try for debugging and flashing the J18 connector with the P&E USB-ML-CF Multilink interface . Unfortunately there is nothing about using this 26 pin header in the documentation. I think the switching could be simply done by not using the OSBDM. So OUT_EN will not connect the signals to the MCU and we can use the external BDM (USB-ML-CF). Is this correct?
Walter
Replies to This Discussion
-
Permalink Reply by Walter Muth on -
Just for info:
Ok ...got the P&E USB-ML-CF working on J18. R21,R22,R23,R25 must be closed of course.
© 2010 Created by TowerGeeks.
